|
|
Дата: 02 Янв 2007 04:15:24
#
Нашёл руководство по увеличению выходной мощности для VX-7R на mods.dk
Почти ничего не понял. Помогите с переводом, и осмыслением написанного.
First of all you don't need any software or soldering jobs for this mode.
You can adjust the high power, L3, L2 and L1 separately on each band.
Start with turning on your VX-7R. Secondly, activate the alignment program by putting the radio to the centres of each band.
To begin, set the transceiver to the centre of 50mhz, 144mhz, 222mhz and 430mhz.
Next, select the 430mhz band, turn the radio off, then hold down the MON/F key, the internet/menu key, and the 0 key, all 3 at the same time and power the radio on.
If you see the letters PLL REF on the display, rotate the dial knob until HI POWER shows on your display. Press now the V/M button and adjust the HI POWER by rotating the dial knob. As higher the number on display will rise, as higher the power will be.
Take a power meter and a 50 ohm dummy for serious results. Press the V/M button again after HI POWER level setting is done. This second pressing of the MON/F button stores the entry. You can adjust the L3, L2 and L1 power levels by the same way too, if you want.
This on every band at the same way. To exit the alignment routine, press the HM/RV button and enjoy the possible high power.
That's up to you, but keep in mind, a higher output power can damage your transmitter by overheating!
Vy 73 de HB9LEI
NO WARRANTY AT ALL. IT'S AT YOUR OWN RISK.
|
|
|
Дата: 02 Янв 2007 09:14:15 · Поправил: Karabas (02 Янв 2007 09:15:30)
#
...but keep in mind, a higher output power can damage your transmitter by overheating!
но имейте ввиду, увеличение выходной мощности (передатчика) приведет к сильному перегреву что может повредит ваш трансивер.
|
